Liquid Damage Repair
Liquid Spills are messy, it's the nature of the job, but we are able to handle Liquid Damage of all sizes with out even breaking a sweat.
Small or Large, we can fix it. We have a Step by Step process we use to ensure a successful long term repair. We first ensure there is no liquid left in the device by placing it in a vacuum chamber to remove all liquid, next we inspect the device for signs of corrosion, Clean and make a list of parts that need to be replaced. From there the Mother Board either heads to our ultrasonic cleaner or to our Board Level Technician for further testing and inspection. Finally we replace the necessary parts do a full clean and reassemble the machine.
Depending on severity and components that are needed to be replaced cost can vary. Liquid Damage machines start with a $75 Diagnosis, a technician will then call with an estimate on what is needed for repair.
Bringing the device to us immediately allows for the best possible chances for repair, we understand this is not always possible. Please use the guide below to help us with repair:
To ensure a SUCCESSFUL repair, please use the following steps IMMEDIATELY after a liquid spill has OCCURRED:
Power off the device ASAP and remove battery if possible.
Take note of where the liquid entered.
Dry off any liquid on the keyboard, Screen or case with a paper towel.
If large amounts of water entered the computer. Try to set it on its side or back with the air vents facing down and let gravity drip any liquid out.
Call Dukky Repair and Let us know what happened, we try to prioritize liquid damage repairs to minimize damage.
Things not to do:
- We do not handle Bio-Hazards of any Kind -
People often tell us "it only just happened, it should be fine right?" or "it was only a small spill" It takes seconds for any amount of liquid to short curcuit components on the board. Check this video out to see how quickly liquid damage happens.